State (Beijing) Medical Technology Co., Ltd.
State (Beijing) Medical Technology Co., Ltd.
Add to Cart
Continuous Enteral Feeding Pump First - Aid Device Nutrition Infusion Pump
Descriptions:
Enteral Feeding Pump is for ambulatory enteral patients.Lightweight with a 14-hour battery,used with disposable feeding bag enteral feeding pump provides feeding and flushing in a completely portable device. This feeding pump is the first hydrating and ambulatory enteral device available. It assures clinicians of accurate and reliable function while providing patients with freedom and mobility.
Working Theory:
Enteral feeding pump consists of shell,control panel,pump cover and peristaltic pump.Through peristaltic pump squeeze pump tubs to reach delivery nourishment.There is a microcomputer in the pump,it can control pump work status,flow rate,required volume and complete alarm,stop pump function.
Features:
Feeding sets are DEHP-free and latex-free
Safe-T-Valve on feeding sets are designed to protect against runaway feeding if set is improperly loaded or becomes dislodged from pump
Free-Flow Alarm: Stops flow and alerts caregiver to free-flow condition when set is properly loaded
Smart Pump: Dial settings designed to take the guesswork out of pump programming—making operation easy to learn, easy to use, and easy to teach
Programmable Hold: If caregiver desires HOLD for other than 5 minutes for patient care, another interval (1 to 90 minutes) may be selected
Lockout Features: Allows caregiver to temporarily disable SET RATE, SET DOSE, and CLEAR VOLUME dial settings to prevent unauthorized or accidental changes
Important Safety Information
THIS PUMP IS FOR ENTERAL USE ONLY - NOT FOR IV USE
Confirm proper placement and function of patient's enteral feeding tube (nasogastric, jejunostomy, gastrostomy, etc) and verify the following before initiating feeding:
1. Only an t Nutrition Enteral Pump Set is being used
2. Flow rate is set at the prescribed mL/hr
Pump set and container should be replaced as needed, or at least every 24 hours, to avoid fluid-contamination problems.
See Pump Operating Manual for Complete Safety Information and Instructions for Use.
Main Technique Parameters:
a) Infusion rate:0ml～999ml,≤±10%
b) Total volume:0.1ml～999ml,≤±10%
c) flow rate:1ml/h～300ml/h；
d) Infusion accuracy:At 1ml/h～50ml/h,range:1ml/h,≤±10%；
At 50ml/h～300ml/h,range 5ml/h,≤±10%
e) Power consumption:13VA
f) Size: 193mm×130mm×105mm
g) N.W:1.6kg
h) Feeding tube:Special feeding tube
Working Conditions:
a) Ambient temperature:5℃～40℃；
b) Relative humidity:30％～80％；
c) Barometric:860～1060hPa；
d) Power supply:AC220V,50Hz
e) Battery:Ni-H2 battery group 9.6V,1600mAh
Alarm function:Sound and light alarm as following situations
a) Without any operating when switched on
b) when reach reques volume
c)low battery
d)Feeding tube is in empty,blocked and folding
e) When working loss of AC supply suddenly
Transportation and storage conditions:
a) Temperature:-40℃～+55℃；
b) Relative Humidity:10％～95％；
c) Atmospheric Pressure:500 hPa～1060hPa；
2, Before transport the pump must be packed accroding to factory package
3, Can not pressure,direct sunlight ,rain and snow during transport
4, Must stored in non corrosive gas,well ventilated condition